Download Commodity

Download Article

Afterward being subjected to years of relentless hugging, squishing and being dragged through the dirt, your teddy bear volition harbour grime that information technology has accumulated over the years, volition have failing seams through which the stuffing is falling out, and won't exist soft and cuddly anymore. Merely no teddy is set for the trash; your teddy can likely exist rehabilitated and made ready for the next generation, as this 25 year onetime bear was.

Steps Download Article

  1. ane

    If your bear does not already have a hole in a seam through which the stuffing can exist removed, very advisedly open a straight seam (such as the back seam) by cutting the seam thread with a scissors, a very sharp pocketknife, or a seam ripper. Remove all of the stuffing and discard.[i]

  2. 2

    Very gently hand-wash the now empty fur in warm water with a mild laundry detergent. Rinse well with warm h2o. Repeat these steps equally necessary, until the wash water no longer becomes coloured with the clay that may come out of the fur. Gently squeeze (do non wring) the fur to remove most of the water.[ii]

    Advertisement

  3. 3

    Remove the backlog water by placing an onetime towel on the floor, placing the affect the towel, folding the towel over the bear, then standing on it. This will squeeze backlog water from the fur without wringing it, which could harm the fabric.[iii]

  4. iv

    Accident dry the comport with a blow dryer, being careful not to scorch the fur. Permit it to farther air dry out overnight to ensure the seams are completely dry.

  5. 5

    Tease out the matted knots if the bear'south fur was matted, after the bear is dry. A dental choice works well. Work the option through the knots, beingness careful not to pull the fur out.

  6. 6

    Turn the teddy conduct inside out to examine each seam for holes and to examine the thread which may be, if the teddy comport is very old, weak and rotten. Sew the holes airtight and reinforce the seams every bit needed, using either a needle and thread or a sewing machine. If a needle and thread is used, be sure to place the stitches close together and pull each stitch tight.[iv]

  7. 7

    Turn the bear correct side out. Examine the seams and areas you've stitched to ensure the seams are tight and the stitches are invisible from the outside. Tight seams are crucial!

  8. 8

    Replace missing eyes if necessary. Buttons work well.

  9. 9

    Make full each of the legs and artillery using a brawl of polyester fiberfill approximately six times the size of the volume of the cavity to be filled, packing each very tightly. Using 1 brawl for each arm and leg is better than filling them with many smaller balls of fiberfill.[5]

  10. 10

    Fill up the head and body crenel, using 1 large clump of fiberfill for each. Pack tightly, ensuring there is enough fiberfill to make the arm, leg and neck joints business firm.

  11. xi

    Sew the seam closed that you've packed the fiberfill through.

  12. 12

    Comb the fur to make it fluffy.

  13. 13

    Apparel your teddy in nice, clean dress, if you and (s)he concur on it.

  14. 14

    Take intendance of your newly refurbished teddy. Information technology'll exist good for decades to come.

    Advertisement

Add together New Question

  • Question

    I take a new teddy bear that has filling that sounds similar it might be hay or something coarse. How practise I go about replacing the filling?

    Community Answer

    You may exist able to apply the filling from pillows. Alternatively, craft stores sell stuffing in large bags that would be suitable.

  • Question

    How could I do that to my teddy? He has feelings.

    Community Answer

    Tell him he is going to hospital and has to take an operation and make it fun. After all, he volition love his new look at the end and so volition you.

  • Question

    Can I use this method if my teddy bear has a attachment?

    Community Answer

    Yeah; because of the zipper, it will be easy to replace stuffing. Just unzip it and take out the old stuffing, replace with new stuffing and zip it back up.

  • Question

    Where can I become filling?

    Community Answer

    Most superstores and dollars stores conduct it.

  • Question

    Do you think I will need to do all that if I bought information technology at a austerity store?

    Community Answer

    It depends how old the teddy bear seems to be. If information technology looks to be in good status, corking! If you can meet loose stitching and matted fur, it might be time to refurbish.

  • Question

    I accept a teddy. She doesn't need to be re-stuffed yet, but her paws are filled with bean handbag beans. The residual is stuffing. How would I go about this?

    swaggycooldragon

    swaggycooldragon

    Community Answer

    You can put stale rice in the paws, or take some bean purse beans out of a bean bag.

  • Question

    My teddy is fine, but its head is dangling slightly like there is no stuffing in that expanse. What can I do nigh this?

    Community Answer

    You could cut the bear on a seam and fill information technology with more stuffing in that area.

  • Question

    If my teddy deport's fur is made out of very expensive material, should I still practise this?

    Community Answer

    It depends on how bad the acquit's condition is. If it has rips and tears, yes.

  • Question

    What practise I practise if the fur is very knotty?

    Community Answer

    Dampen the fur and castor it lightly (if y'all do information technology too hard, the fur might rip out), then look for it to dry out.

  • Question

    My domestic dog ripped the confront off my collectible teddy behave. How tin can I fix this?

    Community Answer

    If you still accept the face, endeavour to sew information technology back on. If not, you could utilise some fabric and button optics. The teddy may non await perfect this manner, just at least it'll take a face.

See more answers

Ask a Question

200 characters left

Include your electronic mail address to become a message when this question is answered.

Submit

Advertisement

  • Use a heavy duty thread. Our case bear was stitched with a thread suitable for sewing denim.

  • If your bear does non accept a pigsty that needs to be repaired through which you tin remove the stuffing, be certain to brand a pigsty just large enough to remove the stuff, as you will take to sew this hole closed when you are finished.

  • When sewing with a needle and thread, use an overcasting stitch.

  • Brand sure you put a generous amount of stuffing in your teddy or he/she might experience one-time and saggy.

  • If your teddy feels a scrap dusty or makes you lot coughing, gently tube vacuum it! It works great! You could wipe him/her with a moisture wipe if she/he is muddy.

Cheers for submitting a tip for review!

Advertizing

  • Do non wring the water out of the fur! Doing so will damage the fur.

  • Use caution when refurbishing a collectible teddy comport -- information technology could lose its value.

  • Don't overstuff your conduct. This will cause your teddy bear to be hard, not fluffy.

  • Do not immerse a bear with hardboard and metal joints. The joints will rot and/or rust. Surface wash information technology only!

  • Utilise a thimble if sewing with a needle and thread.

Advert

Things Y'all'll Need

  • Heavy duty thread, in a colour similar to the colour of the teddy comport
  • A fine pick, such as the dental instrument illustrated
  • Needle or sewing machine
  • Pair of scissors
  • Thimble (if sewing with a needle and thread)
  • A pocketbook of natural cotton or polyester fiberfill (approximately half dozen times the size of the deport)
    • An alternative to fiberfill stuffing is worn out panty hose. If you cull to apply this y'all won't need to have the stuffing out of the bear side by side fourth dimension yous wash information technology. Yous will exist able to machine launder and dry information technology using gentle cycles.

References

Nearly This Article

Cheers to all authors for creating a folio that has been read 175,886 times.

Reader Success Stories

  • Jennifer Schaffnit

    Jennifer Schaffnit

    Mar nineteen, 2018

    "Ebineezer was my cow. I passed him down to my daughter who is at present xv. He was looking his age. I followed all the..." more

Did this article help yous?